To change device configuration parameters, perform the following steps:
1. At the SCSI Configuration Utility Main Menu, select the adapter which
connects to the SCSI device you are reconfiguring. The first adapter listed
controls the operation of the hard disk drives; the second adapter controls
any SCSI removable media devices installed in your system. Press ENTER.
2. Select "Device Selections" and press ENTER. The Devices 0 to 7 screen
displays.
3. Select the SCSI device you are reconfiguring and press ENTER. If you are
configuring SCSI Hard Disk Drives, refer to the SYM53C875 Adapter 1
Table below; if you are configuring SCSI Removable Media Devices, refer
to the SYM53C875 Adapter 2 Table below for recommended settings.
SYM53C875 Adapter 1 – SCSI Hard Disk Drives
Description
Device Selections
Sync Rate
Width (bits)
Disconnect
Read/Write I/O timeout
(secs)
Scan for device at boot time
Scan for SCSI LUNS
Queue Tags
3-20 Configuring Your System
Recommended Setting or
Display Only
Press ENTER for menu.
Select device and press
ENTER.
40
16
On
10
Yes
No
On
Your Configuration
Dev0
Dev1
Dev2
Dev3