Using The Rspf - Sharp AL-2060 Operation Manual

Using the RSPF

• Originals that are A5 to A4 and 56 g/m
Note
maximum of 50 pages can be placed at once.
• Straighten curled originals before placing them in the document
feeder tray. Curled originals may cause misfeeds.
• Place originals horizontally.
• Before placing originals in the document feeder tray, be sure to
remove any staples or paper clips from them.
• When a copy is made, the edges will not be copied (
For the image loss, see the "SPECIFICATIONS" (p.91).
• When using the margin shift function, check the position of the
margins carefully. (p.38)
1
Make sure that an original has not been left on the document
glass.
2
Adjust the original guides to the size
of the originals.
3
Set the original(s) face up in the
document feeder tray.
The RSPF indicator on the operation panel
will light up. If this indicator does not light up,
the originals are not properly set or the RSPF
is not properly closed.
4
Select the number of copies and other copy settings, and then
press the [START] key (
• The default output mode for copying from the RSPF is sort mode
Note
(P.33), and a checkmark "
(P.11). If "SORT AUTO SELECT" is disabled in the user programs,
the default output mode will be non-sort mode. (P.65)
• To stop copying in the middle of a run, press the [CLEAR] key (
• For the copy settings, see pages 27 through 39.
2
to 90 g/m
).
" will automatically appear in the display
MAKING COPIES
2
can be used. A
image loss
).
Original face up
).
3
25