Network > [2] Cellular > (Choose The Sdi2 Cellular Module Or Plug-In Module) - Bosch B5512 Reference Manual

Control Panel
B93x/B94x keypads configuration of IPv6 Server Address
1.
2.
3.
4.
5.
6.
Module Hostname
B91x/B92x keypads configuration of Module Hostname
1.
2.
3.
4.
5.
6.
B93x/B94x keypads configuration of Module Hostname
1.
2.
3.
4.
5.
6.
19.1.8 [2] Network > [2] Cellular > (choose the SDI2 cellular module or plug-in
module)
You can use a B44x cellular communication module for communication. Plug it directly into the
control panel or use it with a B450 module.
SIM APN
SIM Username
SIM Passcode
SIM PIN
SIM APN
B91x/B92x keypads configuration of SIM APN
1.
Bosch Security Systems, Inc.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[3] DNS Parameters > [2] IPv6 Server Address. The keypad shows the DHCP/AutoIP
current configuration.
Press [IPv6 Server Address] to edit the IP address.
Delete the existing number, if necessary, and then enter the new number. Use
or /[NEXT] to move to a different byte.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[3] DNS Parameters > [3] Module Hostname. The keypad shows the IPv4 Server Address
current configuration.
Press [ENTER] to edit the hostname.
Delete existing characters, if necessary, and then enter the new characters.
Press [ENTER] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Enter the installer passcode, and then open the [1] Installer menu.
Go to [1] Program > [2] Network > [1] Ethernet > (choose the bus module or on-board) >
[3] DNS Parameters > [3] Module Hostname. The keypad shows the DHCP/AutoIP current
configuration.
Press [Module Hostname] to edit the hostname
Delete existing characters, if necessary, and then enter the new characters.
Press [Save] to save the programming.
When the keypad shows Parameter Saved, escape from the menu.
Module 1settings
_______________________________
_______________________________
_______________________________
_______________________________
Enter the installer passcode, and then open the [1] Installer menu.
Installation and System Reference Guide
Keypad Installer menu | en
Module 2 settings
_______________________________
_______________________________
_______________________________
_______________________________
2015.07 | 12 | F.01U.287.180
117
/[PREV]