Sharp Aquos Phone es WX04SH Online Manual page 99

Charging Cautions
Never charge handset while it is wet; may cause fire, malfunction
or burns due to electric shock or short circuiting. Be sure to dry it
before use.
Do not touch AC Charger with wet hands. Electric shock may
occur.
Do not use AC Charger in rooms where water is regularly in use
(kitchens, bathrooms, shower rooms, etc.); may cause fire or
electric shock.
If External Device Port is exposed to liquid, never charge handset;
dry handset first (see "Drying
Care & Maintenance
Proper care of Card Slot Cover gasket is crucial for continued
handset water resistance. Observe the following:
・Do not remove or damage gasket. Keep it clean.
・Do not insert a sharp object into Card Slot Cover gap; may
damage gasket and allow ingress of water.
・If Card Slot Cover gasket is damaged or deformed, contact
WILLCOM Service Center or
Telecommunication Services Business Promotion Center
replacement.
To maintain water resistance, it is recommended to replace Card
Slot Cover every 2 years regardless of its condition.
Customer-requested Card Slot Cover replacement incurs fees and
requires handset submission. For details, contact
Service" or a WILLCOM Plaza/WILLCOM Counter.
Washing Handset
Wipe off dirt, sand, beverage, etc., gently with a cloth. Then
hold handset approximately 10 cm below faucet or shower
head and wash with low-pressure tap water (6 liters/min. or
lower) at room temperature (5
hands, taking care not to open Card Slot Cover; do not use a
brush or sponge. Dry handset before use; after drying it well,
power on.
Before washing handset, make sure that Card Slot Cover is closed
firmly.
Do not use a washing machine or ultrasonic cleaner.
Headphone Port and External Device Port tend to accumulate dust,
sand, etc.; rinse and dry them completely before use. Any residue
may cause malfunction, burns or fire.
Do not put a cotton swab, cloth, etc. into Headphone Port or
External Device Port; water resistance may be affected causing
malfunction.
Do not place handset in a microwave oven to dry it. Internal Battery
may leak, overheat, burst or ignite. Handset may overheat, emit
smoke or ignite, causing damage to circuit components.
Do not dry handset using extreme heat (hot air from dryers or
other sources); may cause warping, discoloration, damage, etc.
Handset").
Sharp Corporation Mobile
for gasket
"Customer
o o
C - 35 C). Wash with your
WX04SH
Drying Handset
After exposing handset to water, be sure to dry these parts:
Headphone Port, Earpiece, External Device Port, Mic, Speaker
Wipe handset surface with dry cloth
Holding handset firmly by its sides, shake it about 20
times
When shaking handset, hold it firmly so as not to drop it.
Pat against dry cloth to remove moisture from
grooves
Leave handset on dry cloth for approximately 2 - 3
hours at room temperature
Cautions
When Removing Moisture
Do not put a cotton swab, cloth, etc. into openings.
After Drying Procedure
Do not use handset in wet conditions.
Voice quality may be affected, or moisture may transfer to clothes, bag,
etc.
Moisture may short-circuit Headphone Port, External Device Port or
other parts.
Exposure to cold may freeze moisture and cause malfunction.
12-13