Motorola StarTAC 3000 Service Manual page 20

StarTAC 3000
Table 3: Test Commands For Manual Test Mode
Keypad Command
Entry Description
40# RCVVC
41# -44# (NOT USED)
45# READ RSSI
46# (NOT USED)
47A# AUDLEV
48# SIDETONE ON
49# SIDETONE
OFF
50# - 54# (NOT USED)
55# DISPLAY/
PROGRAM
NAM
56# AUTO-CYCLE
57A# CALL
PROCESSING
MODE
58# COMPANDOR
ON
59# COMPANDOR
OFF
60# & 61# (NOT USED)
62# RNG-ON
63# RNG-OFF
64# PLT-ON
65# PLT-OFF
66# ID TRANSFER
67# (NOT USED)
Status
Display
Receive one voice channel word (wide mode only).
When the word is received it is displayed in hex. This
command will be complete when a voice channel word
is received or when the # key is entered to abort the
command.
Returns the RSSI reading taken on the current channel.
The number is displayed as a three digit decimal
number.
Set audio level where A = level (0 = lowest,
15=highest). The normal level is 2.
NOTE: Use 8 to 15 only for DTMF applications.
Enable sidetone. (Command 05# must also be
executed)
Disable sidetone. (Command 06# must also be
executed)
NAM Displays the contents of the NAM, one step at a time,
advanced by depressing the * key. Only the last 7 digits
of data are displayed.
Radio will alternate between transmit/display and
standby. Transmits on channel 991. Exit by pressing #
key.
A = 1 to enter narrow (NAMPS) mode
A = 0 to return to wide (AMPS) mode
The phone defaults to wide mode on power up.
Turn compandor ON.
Turn compandor OFF.
Turn the APC ringer audio output path ON.
Turn the APC ringer audio output path OFF.
Turn the APC transmit pilot path ON.
Turn the APC transmit pilot path OFF.
Reserved for Identity Transfer Procedure.
14
Result
6/29/98