Motorola StarTAC 3000 Service Manual page 27

Factory
Step
Default
11 00000000
0
0
0
0
0
0
0
0
12 0334
13 0333
14 0334
15 021
16 1010001
1
0
1
0
0
0
1
1
6/29/98
Table 5: Test Mode NAM Programming Sequence
C OPTION BYTE The display for step 11 represents the status of eight
options, C7 through C0. C7 (msb) is programmed first followed by C6-C0.
Bits enter display on the right and scroll left.
User Mode NAM Programming Disable (Bit C7). When set to 1, User
Mode NAM programming cannot be accessed.
Dual NAM Enable (Bit C6). Enter 1 if dual NAM operation is desired (for
models capable of dual system operation). Enter 0 for single NAM
operation.
Bit not used (Bit C5). Enter 0.
Auto Redial Disable (Bit C4). When set to 1, the user cannot access the
6-minute auto redial feature.
Speaker Disable (Bit C3). This bit is used to disable internal handset
speaker when adding V.S.P. option. 1 = handset speaker disabled,
0 = handset speaker enabled.
Bit not used (Bit C2). Enter 0.
Selectable System Scan Disable (Bit C1). When set to 1, the user
cannot select the primary system.
Diversity Antenna Enable (Bit C0). Extended systems only.
0 = Non-diversity, 1 = Diversity.
Initial Paging System. There are 4 significant bits for the initial paging
channel. For system A enter 0333 and system B enter 0334.
Initial A system channel. To initialize system A enter 0333.
Initial B system channel. To initialize system B enter 0334.
Dedicated Paging Channels. Number of dedicated paging channels is
21. Enter 021.
D Option Byte. The display for step 16 represents the status of eight
options, D7 through D0. D7 (msb) is programmed first, followed by D6-D0.
Bits enter display on the right and scroll to left.
Enhanced Scan Enable (Bit D7). Enter 1.
Cellular Connection Enable (Bit D6). Normally set to 0.
Long Tone DTMF Enable (Bit D5). Normally set to 1.
Handset Transducer Disable (Bit D4). Extended system only.
Eight Hour Time-out Disable (Bit D3). Normally set to 0.
Bit not used (Bit D2). Enter 0.
Failed Page Indicator Disable (Bit D1). When set to 1, the failed-call
tone alert feature is disabled.
Bit not used (Bit D0). Set to 1.
Description
21
NAM Programming