Power Supply Setting (+48V); Setting The Encrypted Transmission Function (Encryption); Generating An Internal Signal (Internal Sg); Locking The Power Switch (Power Sw Lock) - Sony DWT-P01 Operating Instructions Manual

For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
+48 V power supply setting
(+48V)
You can turn the +48 V power supply on or
off for microphones that require an external
power supply.
OFF: Power is not supplied to the
connected microphone.
ON: Power is supplied to the connected
microphone.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
Note
The +48 V power supply can be turned on
or off, regardless of INPUT LEVEL setting.
Note, however, that the +48 V power is
actually supplied only when INPUT
LEVEL is set to MIC.
Setting the encrypted
transmission function
(ENCRYPTION)
You can set the encrypted transmission
function.
SECURE KEY: Sets the secure key
method.
PASSWORD: Sets the password method.
OFF: The encrypted transmission function
is not used.
For details, see "Using the Encrypted Transmission
Function" on page 16.
Generating an internal
signal
(INTERNAL SG)
This transmitter generates a 1-kHz
reference level sine wave that can be used to
adjust or check the audio level of the
receiver or the system that you are using.
This internal signal is outside the control of
the attenuator.
1 kHz: A 1-kHz internal signal is
generated.
OFF: An internal signal is not generated.
Note
If the transmitter is turned off while the
reference signal function is on, the function
will turn off automatically.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
Locking the POWER switch
(POWER SW LOCK)
The POWER switch can be locked to
prevent the transmitter from being
accidentally turned off or on.
Even when the POWER switch is locked,
all parts of the transmitter other than the
POWER switch remain functional.
UNLOCK: The POWER switch is not
locked.
LOCK: The POWER switch is locked.
When LOCK is selected, the POWER
switch lock indicator appears in the display.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
Setting Menus 23