LG BNU-BAC Installation & Owner's Manual page 24

How to install
(2) Network environment setup of the BACnet Gateway
• After getting the IP address of the BACnet Gateway assigned from the network administrator, use
the button of the BACnet Gateway to set up the IP address and the network environment of the
BACnet Gateway.
■ Setup procedure
• Set the IP address
• Enter the Gateway address
• Enter the net mask
• Enter the Set BACnet Type
• Check the network environment setting
Note: If the above items are not entered, it is impossible to control the BACnet Gateway or it causes
the communication error, so make sure that all of them are correctly entered.
1. Setting the IP address
① First, press the "MENU/SELECT" button of the BACnet Gateway and selecting "Setting" menu.
When the following menu is displayed on the BACnet Gateway LCD screen, press the
"MENU/SELECT" button again to enter the IP address.
MENU/
SELECT
② Use the up/down/left/right button (▲,▼,◀,▶) to select the desired address.
MENU/
SELECT
③ After entering the last address, press the "MENU/SELECT" button to set the entered address to the
IP address. (When there is no "MENU/SELECT" button input for 5 seconds, the set value is ignored
to return to the existing address.
MENU/
SELECT
24 BACnet Gateway
[LCD screen]
[MENU]
Set IP address
[Example for setting the Gateway address]
[Set IP address]
165.186.002.101
[LCD screen after completing the setup]
BACnet Gateway
SW ver. 1.0.0
[Set IP address]
192.168.000.000