Front Alignment Motor - Canon Finisher-AB1 Service Manual

Chapter 4

4.3.2 Front Alignment Motor

4.3.2.1 Before Removing the Alignment
Motor (frontÅj
1) Remove the stacking wall (upper). (page 4-
5)Reference[Removing
(upper)]
2) Remove the stacking wall (lower). (page 4-
5)Reference[Removing
(lower)]
3) Remove the handling tray unit. (page 4-
20)Reference[Removing the Handling Tray
Unit]
4.3.2.2 Removing the Alignment Motor
(front)
1) Free the cable [2] from the 3 clamps [1], and
disconnect the connector [3].
[2]
F-4-28
2) Free the cable [2] from the 2 clamps [1], and
disconnect the connector [3].
F-4-29
4-8
0015-2128
the Stacking Wall
the Stacking Wall
0015-2129
[1]
[3]
[2]
[1]
[3]
3) Remove the handling tray plate unit [1].
- 1 screw [2] (loosen)
- 1 belt [3]
- 6 screws [4]
- 2 positioning plates [5]
[4] [5] [4]
F-4-30
4) Shift the handling tray aligning plate (front) [1] in
the direction of the arrow, and remove the screw
[2] and the claw [3]; then, detach the handling
tray aligning plate (front).
[3]
F-4-31
[4] [3] [5]
[2]
[1]
[1]
[4]
[2]