LG GD1329CGS Owner's Manual page 34

Part 5 PROGRAMMING MODE -
2 2
Factory reset - EEPt
After a factory reset, all values are reset to the default values.
Entering set up mode.
You will see LqC1
Note
• Dryer default value
- Drying time
- Top off time
3 4
Press the PERM. PRESS or the DELICATES
Button until
Press the START button.
Press the PERM. PRESS button until
display.
Press the START button, then factory reset is done.
is displayed.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• Stack type - 1. Control panel open.
2. Turn on/off toggle switch.
45 Minute
15 Minute
Test Mode
Button
appears in the display.
Display
appears in the