Yamaha RX-A2010 Owner's Manual page 18

1 2 3 4 5 6 7 8
Speaker connections
■
Setting the speaker impedance
This unit is configured for 8-ohm speakers at the factory. When connecting 6-ohm
speakers, set the speaker impedance to "6 Ω MIN". In this case, you can also use
4-ohm speakers as the front speakers.
1
Before connecting speakers, connect the supplied power cable to
this unit and then to an AC wall outlet.
2
While holding down STRAIGHT on the front panel, press
MAIN ZONE .
STRAIGHT
MAIN ZONE
3
Check that "SPEAKER IMP." is displayed on the front display.
SP IMP. - SPEAKER IMP.
DOCK
TAG
HD
STEREO TUNED PRE AMP PARTY
ZONE ZONE ZONE
8 MIN
2 3 4
IN OUT 1 OUT 2
ENHANCER SLEEP
HD 3
4
Press STRAIGHT to select "6 Ω MIN".
5
Press MAIN ZONE to set this unit to standby mode and remove the
power cable from the AC wall outlet.
Now you are ready to connect the speakers.
MUTE VOLUME
ADAPTIVE DRC
PL L C R PR
SL SW1 SW SW2 SR
PL SBL SB SBR PR
18
En