Siemens Gigaset A580 IP User Manual page 158

Hide thumbs Also See for Gigaset A580 IP:
Table of Contents

Advertisement

"Base"
is flashing in the display.
1. The handset is out of range of the base station or the base station's range has
decreased because Eco mode is active.
¥
Move the handset closer to the base station.
¥
If necessary, deactivate Eco mode (
2. The handset has been de-registered.
¥
Register the handset (
3. The base station is not switched on.
¥
Check the base station's mains adapter (
4. The base station firmware is currently being updated (automatically).
¥
Please wait until the update is complete.
Handset does not ring.
1. The ringer is deactivated.
¥
Activate the ringer (
2. Call forwarding set to
¥
Deactivate call forwarding (fixed line network
Page
134).
You cannot hear a ringer/dialling tone from the fixed line network.
The phone cord supplied has not been used or has been replaced by a new cord with the
wrong pin connections.
¥
Please always use the phone cord supplied or ensure that the pin connections are
correct when purchasing from a retailer (
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Re-enter system PIN.
Have you forgotten the system PIN?
¥
Reset the base station to set the system PIN back to 0000 (
The other party cannot hear you.
You have pressed the k key or the
¥
Press the
display key to re-activate the microphone (
§On§
When making calls from the fixed line network, the caller's phone number is not
displayed although CLIP (
Calling Line Identification is not enabled.
¥
The caller should ask his network provider to enable Calling Line Identification (CLI).
You hear an error tone when keying an input (a descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user guide if necessary.
You cannot connect to the router and the phone is assigned a static IP address.
¥
Check on the router whether the IP address is already being used by another device
in the LAN or belongs to the block of IP addresses that is reserved on the router for
dynamic address assignment.
¥
If necessary, change the phone's IP address (
£
Page
£
Page
81).
£
£
Page
93).
All
Calls.
£
§Mute§
display key. The handset is "muted".
£
Page
43) is set.
Service (Customer Care)
79).
Page
18).
£
Page
54; VoIP
Page
169).
£
Page
£
Page
46).
£
Page
101).
£
Page
57/
96).
157

Advertisement

Table of Contents
loading

Table of Contents