Table of Contents
Advertisement
8.3 Setting up Limit Values by Inputting Values (cont.)
8
Opening the value input screen
aaaaoo't
Press the | Zero/Tare | key.
Follow the same procedure as in "Step
2."
9
Setting the upper-limit value
\ I /
~V'T
V"
1
V33WSSB
Follow the same procedure as
described for the lower-limit value and
enter the upper-limit value.
D
y
10 Saving the upper-limit value
Press the ] Memory 1 key.
After saving the upper-limit value, the
balance displays it briefly and
terminates setup.
1.
3.
4.
5.
Key Points of the Procedure it
The limit values you have set can be checked each time you press the | Set [ key.
The balance displays the lower-limit value after showing [L.
S £ t ], and the upper-limit value
after showing [hi
5 E t ]•
Continuous pressing
J
x \ I / /
\ \
Upper-limit value
displayed
1000s
Lower-limit value
displayed
Measurement mode
restored
2.
If you make a mistake, press the | Function] key during the setup of actual quantities or the
1 Set 1 key during the setup of values.
If you press the | Memory | key while a value is flashing, an actual quantity will be set based on
the weight currently loaded on the balance.
Pressing the j Zero/Tare~| key at this time displays
the value input screen.
If the [ ^ ] mark lights up for all three judgement indicators, HI, OK, and LO, the lower-limit value
set exceeds the upper-limit value.
Check the values, since mistakes can occur with entries, as in
cases when the upper-limit value is specified with a negative sign.
When the
Press the
M] mark is flashing on the value input screen, the sign on the left end can be changed.
Zero/Tare"! key to switch between the positive and negative signs.
26
Advertisement
Table of Contents
