Table of Contents
Advertisement
Sustained overloading will cause cable failure and result in possible electrical shock or fire hazard.
Work cable should be the same rating as the torch cable or factory .
Always keep cables and connectors in good condition.
Improper or worn electrical connections can cause short circuits and can increase the chance of an
electrical shock. Do not use worn, damaged, or bare cables.
Always avoid open-circuit voltage.
The added voltages increase the severity of the shock hazard.
Always wear insulated gloves while you adjust equipments.
Power should be shut off and insulated gloves should be worn when making any equipment
adjustment to assure shock protection.
Always wear protective clothing such as long sleeve shorts while
equipments.
Always Wear high, snug fitting shoes.
Always Wear clean clothes without grease or oil.
Do not wear clothing that has been stained with oil and grease. It may burn if ignited by the heat of
the arc.
Protect neighboring workers from exposure to arc radiation.
Always Wear long trousers or jeans while you are installing or removing equipments.
Always wear safety helmet or hard head and safety shoes before work.
Always keep the equipments in dry places.
Always wear safety harnesses/belt while you work in high places.
Always wear dry clothing and avoid moisture and water.
Always wear Public Safety Vest , while you work at night.
Make sure all electrical connections are tight, clean, and dry.
Make sure that you are well insulated and eliminate the electric static charge.
Always wear dry gloves, rubber-soled shoes, or stand on a dry board or platform.
Always Follow recognized safety standards.
Always wear correct eye, ear, and body protection.
Always have second person on-site, while you work in the darkness places, poor ventilation places and
high places.
Make sure that you are well protected against arc flashes, mechanical injury, or other mishaps.
Make sure that the polarity of wire is correct, before installing equipments.
Always handle equipment with care.
Do Not block the ventilation of equipment.
Do Not put the magnetic parts around the Equipment.
Do Not put the objects on top of equipment.
Important information for the correct recycle/treatment procedures of this equipment
The crossed-out wheeled bin symbol printed on the unit label or unit packaging indicates that this
equipment must not be disposed of as unsorted municipal waste but it should be collected separately.
The waste of electric and electronic equipment must be treated separately, in order to ensure that
hazardous materials contained inside the equipment are not buried thereby providing potential future
problems for the environment and human health. Moreover, it will be possible to reuse and recycle some
parts of the waste of electric and electronic equipment, contributing to reduce the quantities of waste to be
disposed of and the depletion of natural resources.
As user of this equipment, you are responsible to return this waste of electronic equipment to an authorised
collection facility set up by your Municipality.
can be obtained from your Municipality or from other competent local entities.
More detailed information on your nearest collection centre
68
you are installing or removing
Advertisement
Table of Contents
