Active Charcoal Filter; Resetting The Charcoal Filter Timer - Miele VENTILATION SYSTEM DA 6290 W Operating And Installation Instructions

Active charcoal filter

In recirculation mode an active
charcoal filter must be used in addition
to the grease filters. It is designed to
absorb cooking odors.
The active charcoal filter will be
replaced in the canopy above the
grease filters.
Replacement active charcoal filters
can be ordered from Miele.
^ To install or replace the charcoal
filter, the grease filters must first be
removed as described in the
previous section.
^ Remove the charcoal filter from the
packaging.
^ Slide the charcoal filter into the rear
of the filter frame. then raise the front
up and push it into the frame.
^ Replace the grease filter.
Before using:
^ Program the charcoal filter timer, see
"Operation / Activating and
reprogramming the charcoal filter
timer".
Cleaning and Care
Replace the active charcoal filter when
the charcoal filter indicator lights, at
least every 6 months or when they no
longer absorb odors efficiently.
Used charcoal filters may be discarded
in household trash.

Resetting the charcoal filter timer

After replacing reset the charcoal filter
operating hours timer.
^ With the fan running, press the
charcoal filter button l— twice and
hold it for approx. 3 seconds, until
only the 1 is flashing.
The charcoal filter indicator light —
will go out.
If the charcoal filter is replaced before
the timer has reached its maximum:
^ Press the charcoal filter button
twice l— and hold it for
approx. 6 seconds, until only the 1 is
flashing.
19