Download Print this page

Hitachi AW18DBL Handling Instructions Manual page 8

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
English
CAUTION
○ If the battery is charged while it is heated because
it has been left for a long time in a location subject to
direct sunlight or because the battery has just been
used, the charge indicator lamp of the charger lights for
0.3 seconds, does not light for 0.3 seconds (off for 0.3
seconds). In such a case, fi rst let the battery cool, then
start charging.
○ When the charge indicator lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign objects in
the charger's battery connector. If there are no foreign
objects, it is probable that the battery or charger is
malfunctioning. Take it to your authorized Service
Center.
○ Since the built-in micro computer takes about
3 seconds to confi rm that the battery being charged with
UC18YSL3 is taken out, wait for a minimum of 3 seconds
before reinserting it to continue charging. If the battery
is reinserted within 3 seconds, the battery may not be
properly charged.
MOUNTING AND OPERATION
Action
Charging
Removing the battery
Attach the nozzle to the trigger gun
Detach the nozzle from the trigger
gun
Attachment order
Attach the high-pressure hose to
the trigger gun
Attach the High-pressure hose to
the water feed outlet of the main
body
Attach the tank to the main body
Inserting the battery
Power indicator
Remaining battery indicator
How to use the variable nozzle
Washing
When supplying water from a
faucet
When using storage water
When operation is completed
Charging a USB device from a
electrical outlet
Charging a USB device and
battery from a electrical outlet
How to recharge USB device
When charging of USB device is
completed
Inspecting the washer and hoses
Inspecting the strainer
Tidying up and storing the washer
after use
Selecting accessories
MAINTENANCE AND INSPECTION
1. Inspecting the washer and hoses (Fig. 21)
NOTE
2. Inspecting the strainer (Fig. 22)
NOTE
3. Clean the washer
4. Check for loose screws.
Figure
Page
5. Tidying up and storing the washer after use
2
282
3
282
4
283
5
283
○ Do not store within the reach of children, or in locations
6
283
○ Do not store in location where rain can reach it, such as
7
283
○ Do not store in locations that are subject to drastic
8
283
○ Do not store in locations containing volatile substances
9
284
NOTE
10
284
11
285
12
285
13
285
14
285
15
286
16
286
17
287
18-a
288
CAUTION
18-b
288
19
288
20
288
21
289
22
289
23
289
290
8
Check to make sure that there is no damage, cracks or
malformations.
Make sure you clean the hole on the nozzle with the
nozzle cleaner pin supplied on a regular basis.
Detach the trigger gun and clean the nozzle hole.
Wash all blockages out of the grid with water on a regular
basis.
Withdraw the strainer from the water feed inlet with the
use of fl at radio pliers.
Squeeze the excess moisture from a cloth soaked in
soap and water and wipe the washer.
Do not use gasoline, thinner, benzene, kerosene, etc.
Failure to observer this may result in malformations.
Check for loose screws on a regular basis and tighten
any screws that are loose. Failure to observe this could
be dangerous.
(Fig. 23)
The accessories can be stored inside the washer as
shown in Fig. 23 when not in use and when being carried
around.
Avoid the following environments and store the washer
and accessories in a safe, dry location when not in use.
where children can use it.
in front of the house, or in locations with high humidity.
changes in temperature or direct sunlight.
that may ignite or explode.
Storing lithium-ion batteries.
Make sure the lithium-ion batteries have been fully
charged before storing them.
Prolonged storage (3 months or more) of batteries with
a low charge may result in performance deterioration,
signifi cantly reducing battery usage time or rendering
the batteries incapable of holding a charge.
However, signifi cantly reduced battery usage time may
be recovered by repeatedly charging and using the
batteries two to fi ve times.
If the battery usage time is extremely short despite
repeated charging and use, consider the batteries dead
and purchase new batteries.
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
Important notice on the batteries for the Hitachi
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used with
batteries other than these designated by us, or when
the battery is disassembled and modifi ed (such as
disassembly and replacement of cells or other internal
parts).

Advertisement

loading