Hitachi SB 10V2 Handling Instructions Manual
Hide thumbs
Also See for SB 10V2:
- Handling instructions manual (52 pages) ,
- Instruction manual (36 pages) ,
- Technical data and service manual (28 pages)
Related Manuals for Hitachi SB 10V2
Summary of Contents for Hitachi SB 10V2
-
Page 1: Belt Sander
Belt Sander SB 10V2 SB 10S2 • Handling instructions SB10V2 Read through carefully and understand these instructions before use. - Page 2 SB10V2...
- Page 3 Lever Idle pulley Drive pulley Shoe plate Sanding belt Rotational direction Adjust screw Inside Outside Move Trigger switch Stopper Dial Support bar Symbols WARNING The following show symbols used for the machine. Be sure that you understand their meaning before use. To reduce the risk of injury, user must read instruction manual.
- Page 5 ×...
-
Page 8: General Power Tool Safety Warnings
Carrying power tools with your finger on the GENERAL POWER TOOL SAFETY WARNINGS switch or energising power tools that have the switch on invites accidents. WARNING d) Remove any adjusting key or wrench before Read all safety warnings and all instructions. turning the power tool on. -
Page 9: Specifications
CAUTION PRECAUTIONS ON USING BELT SANDER Prior to the sanding operation, make sure the material you are going to sand. Hold power tool by insulated gripping surfaces, because If generation of harmful/ toxic dusts such as lead the belt may contact its own cord. Cutting a "live" wire paint, woods and metals is expected under the sanding may make exposed metal parts of the power tool "live"... -
Page 10: Dust Removal
1. How to attach sanding belt 4. How to move machine (1) Pull lever with finger, idle pulley will then move Move mechine forward first and then backward, backward. (Fig. 1) repeating this motion.(Fig. 4) (2) Place on drive pulley and idle pulley passing it over 5. - Page 11 4. Inspecting the carbon brushes For your continued safety and electrical shock protection, carbon brush inspection and replacement on this tool should ONLY be performed by a Hitachi Authorized Service Center. 5. Replacing supply cord If the supply cord of Tool is damaged, the Tool must be returned to Hitachi Authorized Service Center for the cord to be replaced.
- Page 16 Hitachi Koki Co., Ltd. Code No. C99159622 M Printed in Malaysia...