Other Sources Of Information - Brother NC-9100h Network User's Manual

12
Change context if necessary and select the print queue you
created. Click OK and then OK again, and then exit NWADMIN.
13
Start the appropriate BRAdmin Professional utility, and select
the correct print server you wish to configure (by default, the
node names will begin with BRN_xxxxxx_P1 )
You can find the NetWare server name and MAC address by
printing out the DCP/MFC configuration page. Refer to the
User's Guide Chapter 23 for information on how to print the
configuration page on your print server.
14
Double click the appropriate Print/Fax server. You will be
prompted for a password, the default password is access .
15
Now select the NetWare tab.
16
Select Remote Printer as the Operating Mode, select the
name of your PSERVER NLM as the Print/Fax server Name and
select the number of the printer from step 6 as the Printer
Number.
The same service assigned by NetWare Print/Fax server
cannot be used for both queue server mode and remote
printer mode. If you want to enable remote printer capabilities
on a service other than the default NetWare service, you
must define new services that are enabled for NetWare and
for the desired port.
17
Click OK. And exit BRAdmin Professional utility.
You must now unload the PSERVER NLM from your NetWare file
server console and then reload it in order for the changes to take
effect.

Other Sources of Information

1
Visit http://solutions.brother.com/ for more information on
network printing.
2
Refer to chapter 11 of this user guide to learn how to configure
the IP address of the printer.
NOVELL NETWARE PRINTING 6 - 13