Sharp 64LHP5000 Service Manual page 16

64LHP5000
PROJECTOR UNIT
Ë Assembly Adjustment Location Guide
B
If POWER SUPPLY ASSY
If DEFLECTION ASSY
C
If VIDEO ASSY
If TUNER µ-COM ASSY
A
If AMP ASSY
If R, G or B CRT DRIVE ASSY
If CRT ASSY
If LENS ASSY
If SIGNAL ASSY
If SUB VIDEO ASSY
If CONVER. DAC ASSY
If OTHER ASSY
(*1) When replacing the tuner u-com assembly, mount the IC2204 (24LC32A:E
adjustments.
is repaired
is replaced
is repaired or replaced
is repaired or replaced
the µ-COM block
the tuner block
(*1)
is replaced
is repaired or replaced
is repaired or replaced
R, G, B or deflection yoke is replaced
is replaced
is repaired or replaced
is repaired or replaced
is repaired or replaced
is repaired or replaced
1 Power supply adjustment
No adjustment is required
7
Focus VR adjustment
8 Vertical size adjustment
9 Horizontal size adjustment
10 Convergence adjustment
13 White balance adjustment
3 Brightness adjustment
13 White balance adjustment
14 SHARP's standard settings
15 Side panel adjustment
2 Contrast coarse adjustment
3 Brightness adjustment
11 Test cross H-center position adjustment
14 SHARP's standard settings
12 Tuner block adjustment
All the above adjustments except for the
position adjustment and tuner adjustment are required.
8 Vertical size adjustment
Horizontal size adjustment
9
10 Convergence adjustment
3 Brightness adjustment (SHARP's standard settings)
13 White balance adjustment
4 Deflection yoke lean adjustment
5 Screen center adjustment
7 Focus VR adjustment
10 Convergence adjustment
13 White balance adjustment
14 SHARP's standard settings
6 Focus adjustment of lens assy
10 Convergence adjustment
Check white balance. If the best screen is not obtained, adjust
13
White balance adjustment
16 SPLIT screen adjustment
13 White balance adjustment
14 SHARP's standard settings
10 Convergence adjustment
No adjustment is required
2 PROM)on the current assembly to the new one to facilitate
16
test-cross H-center
11