Analog Monitor Connections - LG LST-5100P Owner's Manual

Connections (Continued)
Display Formats Overview
The HDTV Receiver offers various display formats and multiple video outputs.When the HDTV Tuner is connected
•
to A/V systems, the HDTV Tuner can provide video signal formats 1080i, 720p, 576p, and 576i.
1080i, 720p, 576p, and 576i modes are available for component video (YPbPr)outputs.
•
1080i, 720p, and 576p modes are available for RGB and DVI outputs.
•
576i mode is available for VIDEO, S-VIDEO, and COMPONENT VIDEO outputs.
•
The HDTV Tuner has two digital audio outputs;Dolby Digital 5.1 and PCM.The HDTV Tuner sends out a digital
•
audio signal to OPTICAL and COAXIAL audio outputs when digital broadcasts are being received by the HDTV
Tuner.

Analog Monitor Connections

Antenna
Connect the "Antenna" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1 1
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an attenuator. Screw the attenuator onto the "ANT IN" jack. (Refer to page 9.)
Connect the "ANT LOOP OUT" jack on the HDTV Receiver to the "Antenna In" jack on your TV using a coaxial
2 2
RF cable.
Connect the "AUDIO OUT" and "VIDEO OUT" jacks on the HDTV Receiver to the "A/V IN" jacks on your TV
3 3
using RCA-type cables. If your TV is equipped with an S-Video jack, use the S-VIDEO OUT jack.
(The Output Selection must be set to YPbPr, refer to Display Format Setup on page 16.)
ote
When using Composite VIDEO OUT (yellow connector) or S-video outputs from HDTV Receiver, MENU will only
appear and operate if 576i format is selected.
10
Antenna
Wall Jack Panel
OR
TV Connection Panel
ANTENNA VIDEO
AUDIO INPUT
INPUT INPUT
L R L
OR
HDTV Receiver Connection Panel
S-VIDEO
INPUT