Hd Monitor Component (Ypbpr) Connections - LG LST-5100P Owner's Manual

Connections (Continued)

HD Monitor Component (YPbPr) Connections

Antenna
Connect the "Antenna" to the "ANT IN" jack on the HDTV Receiver using a coaxial RF cable.
1 1
ote
There might be some areas where the signal strength could be too high. If so, you may need to connect the
antenna to an attenuator. Screw the attenuator onto the "ANT IN" jack. (Refer to page 9.)
Connect the "ANT LOOP OUT" jack on the HDTV Receiver to the "Antenna In" jack on your TV using a coaxial
2 2
RF cable.
Connect the "COMPONENT OUT" jacks on the HDTV Receiver to the "COMPONENT IN" jacks of your TV
3 3
using RCA-type cables. (The Output Selection must be set to YPbPr, refer to Display Format Setup on page
16.)
Connect the L/R "AUDIO OUT" jacks on the HDTV Receiver to the L/R "AUDIO IN" jacks on your TV using
4 4
RCA-type cables.
ote
1080i, 720p, 576p, and 576i modes are available for component video (YPbPr) outputs.
Antenna
ANTENNA
Wall Jack Panel
INPUT
OR
HD Ready TV Connection Panel
AUDIO INPUT
COMPONENT VIDEO INPUT
Y
Pr Pb
L
HDTV Receiver Connection Panel
VIDEO
INPUT
R
11