Error Code - Panasonic NP-B6M1FIGB Service Manual

4.3.

Error code

Error code
The possible errors and the relative LED displays are shown below. If an error is detected during
the test mode, correct the error and then open and close the door to continue with the test.
ERROR CODE
E1 The flood prevention system has been activated
E3 Does not heat up
E4 Temperature probe disconnected
E5 Does not fill
E6 Does not drain
E7 Malfunction of turbine water meter (flow meter)
E8 Malfunction of alternating valve
E9 Fill level limit exceeded
E10 Malfunction of turbidity sensor
Malfunction
14
What the display shows