Installer Setting - Static Pressure Setting - LG PREMTB10U Installation & Operation Manual

Installer Setting - Static Pressure Setting

This function is applied to only duct type. Setting this in other cases will cause malfunction.
<Static Pressure Setting Table>
Pressure selection
01 V-H
02 F-H
03 V-L
04 F-L
INSTALLATION INSTRUCTIONS
Press the button for 3
1
seconds to enter the
Thermostat installer setting.
- If pressed for a shorter time,
it enters into user setup mode.
If pressing
2
moves to static pressure selection menu
as picture below.
Select static pressure by pressing
3
buttons.
(01:V-H, 02:F-H, 03:V-L, 04:F-L)
Function Code Pressure
Press button to save.
4
5
Press button to exit settings mode.
After setup, it automatically exits after 25
seconds if there is no input. If the
Setting/Cancel button is not pressed, the
mode will not change.
Function
Zone state
Variable
Fixed
Variable
Fixed
button repeatedly, it
ESP standard value
High
High
Low
Low
73