Mitsubishi Electric Jet Towel JT-SB116JH-G-NA Installation Manual page 10

Installation (Continued)
Fix the main unit in place.
1.Engage the panel hooks of the installation
panel (2 hooks) on the back of the unit.
If the wall is concrete, use commercially available
metal screw plugs.
Use a screwdriver that is longer than 6"(150mm).
2.Check that the power cable is not trapped
behind the main unit.
7
Adjust the length of the power cable in the
Electrical Conduit/Tubing so that the power cable
does not become trapped.
3.Gently press the unit onto the wall, and fi x it
in place using the mounting screw (1).
■ Switching the air speed switch and heater switch settings
Check the heater ON/OFF settings and air speed HIGH/STANDARD settings with the
customer beforehand.
(The user cannot adjust the settings after installation is complete.)
Caution
Do not install when the product (power cable) is
electrifi ed.
Doing so may result in electric shocks.
1.Remove the mounting screw (1) from
the switch box cover, and remove the
8
switch box cover.
2.Change the settings.
3.After checking the switches, fi x the
switch box cover back in its original
position.
Mounting screw
(Included)
Longer than 6"(150mm)
Switches
Switch box cover
OFF ON
STANDARD HIGH
※
Factory default settings
Settings
HEATER OFF / ON
STANDARD / HIGH
AIR SPEED
− 10 −
Back panel
HEATER
Mounting
AIR SPEED
screw
Panel hooks
Power cable
Green striped
bonding wire
Panel hook