Yamaha YZF-R6(V) 2006 Service Manual page 256

• Stake the clutch boss nut at a cutout "a" in the
main axle.
Universal clutch holder
90890-04086
YM-91042
a
3
5. Lubricate:
• Friction plates
• Clutch plates
(with the recommended lubricant)
Recommended lubricant
Engine oil
6. Install:
• Friction plates
• Clutch plates
NOTE:
• First, install a friction plate and then alternate
between a clutch plate and a friction plate.
• Install the last friction plate "1" offset from the
other friction plates "2", making sure to align a
projection on the friction plate with the punch
mark "a" on the clutch housing.
1
2
a
7. Install:
• Pressure plate "1"
NOTE:
Align the punch marks "a" in the pressure plate
with one of the three punch marks "b" in the
clutch boss.
1
8. Install:
• Seat plate
• Clutch springs
• Clutch spring bolts
2
NOTE:
Tighten the clutch spring bolts in stages and in a
crisscross pattern.
9. Install:
• Dowel pins
• Clutch cover gasket
• Clutch cover "1"
NOTE:
• Position the pull rod so that the teeth "a" face
towards the rear of the vehicle. Then, install the
clutch cover.
• Apply locking agent (LOCTITE
of only the clutch cover bolts "a" shown in the
illustration.
• Tighten the clutch cover bolts in stages and in
a crisscross pattern.
5-45
a
b
Clutch spring bolt
8 Nm (0.8 m·kg, 5.8 ft·lb)
New
Clutch cover bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)
®
CLUTCH
1
) to the threads