How To Install The Stand - Sanyo HEC-DR5700 Instruction Manual

HOW TO INSTALL THE STAND

Tools needed: Phillips (crosshead) screwdriver (＊screwdrivers are not included)
1
Secure the stand on the right-hand
side of the arm rest, using the
installation screws (3 screws).
2
Put the remote control on the
remote control stand (upper part).
Put the sensor controller on the
sensor controller stand (lower part).
Put the remote control on the remote control
stand in a tilted position as arrow
and then push it in the direction of arrow
①
Remote control
Sensor
controller
9
hand screw
Installation
screws
shows,
①
②
Remote control
stand
If the remote
control stand
moves too
loosely,
tighten the
hand screw.
Sensor controller
stand
3
Place the sensor cable into the
hook on the left side of the sensor
stand.
Stopper
Attach so that the
stopper is set into
the top of the hook.
4
Place the remote control cable into
the hook on the right side of the
sensor stand.
5
.
②
Using the hook-and-loop fasteners
attached to the case, fasten it
around the sensor controller stand,
as shown in the figure.
Form a ring with the hook-and-loop fasteners
and fasten it around the sensor controller stand.
Hook Hook
-and- -and-
loop loop
fasteners fasteners
Hook
Sensor controller
cord
Remote control cord
Hook
-and-
loop
Sensor
fasteners
controller
stand
Hook