Table of Contents
Advertisement
Installation and connection
Important warnings
The appliance may only be connected by a qualified electrician.
• The appliance should be fitted with a device that disconnects it from all poles of the home
network (an omnipolar switch), with at least 3 mm of distance between the contacts in
open position. Miniature circuit breakers or fuses are appropriate.
• To connect the appliance, use the rubber mains cords (type HO5RR-F with the green/
yellow earth wire), PVC insulated (type HO5VV-F with the green/yellow earth wire), or
other equivalent or superior cables. The cable must be rated at 16 Ampere or greater. The
screw terminals can accept conductors between 1.5mm² and 6.0mm².
• Veneer, glue, or plastic finish of the furniture next to which the cooker is installed, should
be heat resistant (100°C). If the veneers are not high temperature resistant, they may be
damaged.
• Packaging (plastic foil, polystyrene, etc.) must be kept out of reach of children and
disposed of in the correct manner. Small parts can be swallowed by children and plastic
can pose a risk of suffocation.
Installation
36
• Veneer or other finish of the furniture the appliance is being
built into should be processed with heat-resistant glue
(100°C); otherwise, high temperatures may cause them to
deform.
• Before installing the appliance, remove the back wall from
the piece of kitchen furniture the appliance is being built
into, along the entire length of the cutout.
• The installation cutout should be dimensioned as indicated
in the figure.
• The bottom panel of the piece of kitchen furniture (Max.
530 mm) should always be shorter than the side walls to
enable adequate air circulation.
• Level the piece of furniture the appliance was built into with
a spirit level.
• The piece of kitchen furniture the appliance is built into
must be secured against movement, e.g. Attached to the
adjacent pieces of kitchen furniture.
• Push the appliance into the kitchen furniture enough that
the guides for the screws that are inserted in the oven
frame holes are placed against the kitchen side walls.
• When attaching the appliance, make sure the screws are
not fastened too strongly as this may damage the furniture
or the appliance enamel coating.
Advertisement
Table of Contents
