Motorola 326X V.34 User Manual page 148

Table A-1.
AT Commands, Cross-Referenced to Front Panel Options (Continued)
AT Parameter &
Command Option
*
AT OP4 =2H/1L
*
AT OP5 =2H/3L
*
AT OP6 =2H/4L
*
AT OP7 =3H/1L
*
AT OP8 =3H/2L
*
AT OP9 =3H/4L
*
AT OP10 =4H/1L
*
AT OP11 =4H/2L
*
AT OP12 =4H/3L
Overspeed
*
AT OS0 =1%
*
AT OS1 =2.5%
Password
*
AT PE0 =Disable
*
AT PE1 =Enable
*
AT PF Set Protection
*
AT PN Unlock Pass-
word Protection
Dial
*
AT PT0 =Tone
*
AT PTl =Pulse
Gray shading indicates country-specific options. See Appendix C for your country's options.
A-26 Configuration Quick Reference
Description
Overspeed
Lets modem compensate when an async DTE sends data to the modem faster than specified.
The modem compensates for DTE overspeed up to 1.0%.
The modem compensates for DTE overspeed up to 2.5%.
Enable/Disable Password Protection
Enables and disables the Password function. Once you have enabled the Password function, set
protection in order to lock the modem (see AT
Disables the Password function.
Enables the Password function.
Lets you set protection to lock the modem. Refer to AT
If you know your password, to unlock a password-protected modem and gain access to all
*
modem functions, use the AT
If you forget your password, you can regain access to all modem functions by performing the
following procedure.
IMPORTANT: When you unlock a modem with this procedure, option settings and
telephone numbers are deleted from modem memory. Before using the modem again,
reconfigure option settings and re-enter stored telephone numbers.
1)Close Switch 4 on the rear panel (set it to down position). See Table A-6 for details.
2)In the Status/Option Sets/Dialing menu, press
3)When you press , the modem displays Reinit All Mem?
4)Press again. The modem displays 326x Initial
5)The modem is now reset to factory default settings and all electronic telephone book entries
are deleted. Password protection is disabled and the password is set to 0000.
6)To use the password protection feature again, open Switch 4 on the modem rear panel (set it
to up position).
Dial Type
The modem uses tone dialing unless otherwise specified by the T or P dial modifiers in a
telephone number.
The modem uses pulse dialing unless otherwise specified by the T or P dial modifiers in a
telephone number.
*
PF).
*
PN for details.
PNxxxx command (where xxxx is the password).
until Reinit Memory? displays