Introduction; Features; Operating Considerations - Hitachi KP-D5000 Operation Manual

Introduction

Hitachi's KP-D5000 series is a high sensitivity and high
resolution CCD color camera utilizing a newly developed
digital signal processor (DSP) possessing a wide
dynamic range.

Operating considerations

Power supply
1) Note that it will take few seconds after power on until a
picture is displayed on the monitor.
2) Switching regulator is used in power circuit of this camera.
Therefore, when power supply (AC 100V) is raised slowly,
camera may not operate normally. In this case, turn off the
power and turn on it after few seconds.
Handling
1) Do not attempt to remove cover.
2) Before plugging or unplugging a connector, be sure to turn off
power.
3) When installing or removing a lens, take care that water or
dust does not enter inside of the camera
Installing and storage
Avoid installing or storing the camera in the following
environments.
・Environments exposed to direct sunlight, rain or snow
・Where combustible or corrosive gas exists.
・Excessively warm or cold environment (Operating
temperature : 0 to 40℃).
・Humid or dusty environment.
・Place subjected to excessive vibration or shock.
・Environment exposed to strong electric or magnetic field.
・Do not aim the camera lens at the sun.
・Do not shoot strong light or a scene including strong light.

Features

High sensitivity, high resolution
The high density interline type CCD sensor with on-chip
micro lenses and low noise circuit design enables low-light
pickup down to 0.03lx (with F1.2 lens, AGC maximum).
Horizontal resolution of 560 TV lines were achieved by
adopting digital signal processing technology of 380,000
(440,000 PAL) pixel CCD.
High resolution
・Digital signal processing LSI.
・Contour compensation by digital technology and 2H
vertical enhancer.
Various functions
・Auto tracking white balance (ATW)
・Color/monochrome switch
・Digital noise reduction (DNR)
・Fog adjustment
・Backlight compensation (BLC)
・Electric shutter
・Electric sensitivity enhance
・Digital zoom
・Text display
・Dial type flange back adjustment mechanism
1
To obtain stable performance for long time
When the camera is used continuously for long time under
high ambient temperature, the internal electrical parts become
deteriorated, resulting in short life. To use the camera
continuously for long time, the highest temperature must be
below 40℃.
Cleaning
・Use a blower or a lens brush to remove dusts on the lens or the
optical filter.
・ To remove dirt on the cover, use dry soft cloth. lf dirt is
hardened, wipe with a moist cloth of neutral detergent liquid.
・Do not use benzine, thinner, alcohol,liquid cleaner or
spray-type cleaner.
・In event dust or other debris is lodged between the CCD and
optical filter, consult dealer for cleaning it.
2