Connections - Hitachi KP-D5000 Operation Manual

KP-D5010
REMOTE connector [REMOTE]
Used to remote control the camera
setting
Refer to page 42(Remote operation
of setting menu).
Power supply input terminal
Refer to page 8 (Power supply connection).

Connections

Video output connection
Video output is connected from the camera back panel to the
video imput of the monitor via coaxial cable. If two or more
monitors are connected in a loop, set the 75
the final monitor to ON.
The type of coaxial cable (75 ) is decided according to the
distance with the connected device. The standard maximum
cable lengths without any unmarkable deterioration of image
are as follows.
・・・・ 150m
3C-2V
・・・・ 200m
5C-2V
・・・・ 300m
7C-2V
・・・・ 400m
10C-2V
KP-D5000 / KP-D5001
Color monitor
/ KP-D5010
No.1
75 coaxial 75 coaxial
cable
Set the 75 switch of only the final monitor to on.
ＲＥＭＯＴＥ
switch of only
Color monitor Color monitor
No.2 No.3
75 coaxial
cable cable
Camera menu setting operation switch [SETUP]
Various
confirmed and changed with these 3 switches.
Refer to page 15 (Setting menu operations).
Ｕ
ＳＥＴ
ＳＴＡＴＵＳ
ＶＩＤＥＯ Ｄ
ＰＬＡＴＥ ＲＡＴＥＤ
ＤＣ
ＳＥＲ．ＮＯ．
１２Ｖ
② ② ② ② ① ① ① ①
7
Power cable connection
KP-D5000
Power supply input ratings
AC24V AC24V
AC24V AC24V
① ① ① ① 1-L
② ② ② ② 2-N
③ ③ ③ ③ GND
Power supply input specification
：16～28AWG
Any special power supply is not required. Be sure to use the
power source specified in the specification.
(Please use the power supply of current capacity of 1A or
more, though it depends on the connected devices.)
Morever, please note that there is polarity in the 12V DC
power supply.
8
setting and adjustment
Status lamp
・Normal startup status：Green
・External synchronous mode：Orange
Video output connector [VIDEO]
Refer to page 8 (Video output
connection).
KP-D5010
Power supply input ratings
DC12V DC12V DC12V DC12V
DC12V DC12V DC12V DC12V
○ ① ① ① ① ○
+ +
○ - (GND) ② ② ② ② ○ - (GND)
Not used
Power supply input specification
values are
：16～28AWG