Table of Contents
Advertisement
5 - ELECTRICAL SECTION
WARNING!
- This product is not supplied with a
mains cable.
- This appliance must be earthed.
- Your hob must be installed by a quali-
fied electrician in line with all electrical
and installation requirements published
by the Institute of Electrical Engineers.
To connect the mains cable to the hob it
is necessary to carry out the following
operations:
Unscrew the shield "A" at the bottom
of the hob.
Ensure the links "C" (fig. 5.1) are fitted
into the mains terminal board "B" as
shown in (fig. 5.2).
Insert the mains cable type 3x4mm
through the hole of the shield "A"
Connect the wires to terminal board "B"
according to the diagram in fig. 5.2 and
the earth wire to clamp "D".
Secure the mains cable with cable
clamp "E".
Refit the shield "A".
D
E
18
B
A
C
Fig. 5.1
IMPORTANT:
This appliance requires a 30 amp
supply.
A double pole switch must be provided no
further than 2 metres from the appliance to
the electrical supply.
All supply current and earth conductors
must be able to withstand an ambient tem-
perature of 75°C.
The appliance must be connected using
2
3x4 mm
cable (not supplied).
NOTE: This appliance is intended to be
permanently connected to fixed wiring.
If you are using the hob for the first time, or
2
after a period of disuse, you should set the
controls to position 1 for approximately 30
seconds, to dry out any humidity.
If the supply cord is damaged, it must be
replaced by a special cord by a qualified
electrical technician in order to avoid a haz-
ard.
1 2 3 4 5
Connection of cables inside the hob
PE
L
N
Fig. 5.2
Advertisement
Table of Contents
