Rotation Sending Setting; Recall In Case Of Communication Error; Quick On Line Sending; Call Timer At Memory Sending - Sharp AR-FX7 Operation Manual

KEY OPERATOR PROGRAMS

ROTATION SENDING SETTING

When transmitting a document, this setting allows you
to rotate a vertically oriented 8-1/2" x 11" document to
a horizontal orientation (8-1/2" x 11"R), or rotate an A4
document to A4R. The document is rotated clockwise.
(8-1/2" x 11"R and A4R documents are not rotated.)
KEY OPERATOR PROGRAMS
ROTATION SENDING SETTING
ORIGINAL
SET
1
8 / x11
2
A4
Rotation settings can be established separately for
different document sizes. To disable a rotation setting,
touch the checkbox of the appropriate setting to
remove the checkmark.
This program is initially enabled for all paper sizes
(factory default settings).

CALL TIMER AT MEMORY SENDING

When sending a fax by automatic transmission
("Storing transmission jobs (memory transmission)"
(p.15)), this setting lets you select the amount of time
that the machine waits before breaking the connection
when the other machine does not respond to your
machine's calling tone. If the other machine does not
respond within this set time, your machine will
automatically break the connection.
Time selections are [30 sec.], [45 sec.], and [60 sec.].
The factory default setting is "45 sec.".

RECALL IN CASE OF LINE BUSY

When sending a document, this setting is used to
select whether your machine will automatically
re-attempt the call when the other machine fails to
answer or the line is busy. The number of recall
attempts can be set from 1 to 14, and the interval
between attempts can be set from 1 to 15 minutes in
increments of 1 minute. To disable automatic recalling,
select the [NO RECALL] checkbox.
The factory default settings are as follows:
• NUMBER OF TIMES: 2 (times)
• INTERVAL: 3 (min.)
100
OK
SENDING
DIRECTION
1
8 / x11R
2
A4R
RECALL IN CASE OF
COMMUNICATION ERROR
When sending a document, this setting is used to
select whether your machine will automatically
re-attempt the call if the transmission fails due to a line
error. One recall attempt or no recall attempts can be
selected, and the interval until the attempt can be set
from 0 to 15 minutes in increments of 1 minute.
The factory default settings are as follows:
• NUMBER OF TIMES: 1 (times)
• INTERVAL: 1 (min.)

QUICK ON LINE SENDING

When this program is enabled and memory
transmission is selected, the machine will call the
receiving machine while the original pages are being
scanned and begin transmission from pages that have
finished scanning.
When the program is disabled, transmission will not
begin until all pages have been scanned (with the
exception of manual transmission and direct
transmission). ("Quick On-line" (p.14))
This program is initially enabled (factory default
setting).
DEFAULT SENDING MODE
This program is used to select [MEMORY TX] or
[DIRECT TX] for the default transmission mode. For
more information on these modes, see page 14.
The factory default setting is "MEMORY TX".
AUTO COVER SHEET
When this program is enabled, a cover page is
automatically generated and added to each fax
transmission. The cover page shows the date, time,
destination name, destination fax number, sender's
name, sender's fax number, number of pages, and a
message if the message function is selected. A cover
sheet cannot be added when scanning a document
into polling memory or F-code polling memory, or
when performing polling, direct transmission, relay
broadcast transmission, F-code relay broadcast
transmission, or manual transmission.
This program is initially disabled (factory default
setting).
SLOW SCAN MODE
When this program is enabled, thin-sheet scanning is
selected by default when an original is scanned using
the RSPF.
Thin-sheet scanning uses a slower scanning speed to
prevent thin originals from misfeeding.
This program is initially disabled (factory default
setting).