Panasonic EH-SW50 Operating Instructions Manual page 34

Problem
No steam comes out from the
appliance after a few minutes
after pressing the "电源/温度"
(power/temperature) switch.
• Steam is invisible.
The main unit does not heat
up.
The appliance stops during
use.
The temperature indicator
lamp and rhythm indicator
lamp are blinking
Will the battery be exhausted
after a long period of disuse?
Can the battery be charged
before every use?
If the problems still cannot be solved, contact the store where you purchased the unit or a service center
authorised by Panasonic for repair.
34
EH-SW50_CH.indb 34
Possible cause
The water supply plate is not wet.
The water supply plate is not firmly
attached.
The appliance may not function if used at
a temperature other than the
recommended temperature range.
The battery is empty.
The appliance automatically stops after
approximately 12 minutes.
This does not indicate a problem.
The self‑protection function inside the
main unit was tripped.
When the appliance is not used for 6 months or more, the battery will weaken
(leak battery fluid, etc.). Fully charge the battery once every 6 months.
(See page 27.)
Yes, but it is recommended that you charge the battery when it is empty. The
life of the battery will vary depending upon usage and storage conditions.
Action
Wet the water supply plate.
(See page 27.)
Firmly attach it.
(See page 27.)
Use at the recommended use
temperature of 15 °C ‑ 35 °C
Recharge using the AC adaptor.
Turn off the power and restart the
operation.
(See page 32.)
2013/04/16 19:42:54