Solving Setup Problems; Noise After Filling The Ink; Software Installation Problems - Epson L310 User Manual

• If the page does not print, the product may have a problem. Check the other solutions in this
manual. If they do not work, contact Epson.
Parent topic:
Related concepts
Uninstall Your Product Software
Print Head Alignment
Print Head Cleaning
Related references
Where to Get Help

Solving Setup Problems

Check these sections if you have problems while setting up your product.

Noise After Filling the Ink

Software Installation Problems

Parent topic:
Noise After Filling the Ink
If you hear noises from your product after filling the ink tanks with ink, check these explanations:
• The first time you fill the tanks with ink, the product must charge its print head. Wait until charging
finishes before you turn off the product, or it may charge improperly and use excess ink the next time
you turn it on. Your product is finished charging the print head when the
• If the product's print head stops moving or making noise, and the charging process has not finished
after approximately 20 minutes, turn off your product. Turn it back on and check to see if charging is
still in progress. If it is still in progress, contact Epson for help.
Parent topic:
Related tasks
Refilling the Ink Tanks
Software Installation Problems
If you have problems while installing your product software, try these solutions:
• Make sure your product is turned on and any necessary cables are securely connected at both ends. If
you still have problems installing software, disconnect the cable and carefully follow the instructions on
the Start Here sheet. Also make sure your system meets the requirements for your operating system.
Solving Problems
Solving Problems
Solving Setup Problems
89
power light stops flashing.