Acer Altos R360 F2 Frequently Asked Questions Manual page 22

Altos R360 F2 FAQ (Frequently Asked Questions)
d. Please configure the settings for iSCSI boot to meet your iSCSI Target in storage system environment.
Below is an example of iSCSI boot configuration.
========== iSCSI Boot Configuration ==========
[ ] Use dynamic IP configuration (DHCP)
Initiator Name:
Initiator IP:
Subnet Mask:
Gateway:
VLAN ID:
[ ] Use DHCP for iSCSI Target information
Target Name:
Target IP:
Target Port:
Boot LUN:
Press spacebar to change
[OK]
e. Save the settings and reboot the system.
During POST, you would see the information below when system detects the iSCSI storage.
Intel (R) iSCSI Remote Boot version 2.7.97
Copyright (c) 2002-2011 Intel Corporation. All rights reserved.
Press ESC key to skip iSCSI boot initialization.
Linking up adapter port – MAC address(0015176C7958).
Using STATIC configuration for primary port, please wait.
iSCSI Target Name
iSCSI Target IP Address : 192.168.10.201
LUN ID: 0
iSCSI Initiator IP
iSCSI Gateway IP
iSCSI Initiator Name
Attempting to connect to target disk using MAC address(0015176C7958)
LUN: 0 DEVICE: HITACHI DF600F 40.0 GB
7. Do I need to enable iSCSI boot to support iSCSI function on onboard Gigabit?
ANSWER: NO, to access iSCSI storage, you don't need to enable iSCSI boot feature of onboard Gigabit. ANSWER: ANSWER: ANSWER:
You only need to enable iSCSI boot feature when you want to install OS on remote iSCSI storage and let OS
boot from remote iSCSI storage.
8. How do I specify the IQN (iSCSI Qualified Name) in Windows Server 2008 R2?
ANSWER: Please launch the Microsoft iSCSI Software initiator and select Configuration tab. You can specify ANSWER: ANSWER: ANSWER:
the IQN by clicking Change.
iqn.2008.com.ac
192.168.10.50
255.255.255.0
0.0.0.0
iqn.1994-04.jp.c
192.168.10.201
3260
0
[Cancel]
: iqn.1994-04.jp.co.hitachi:rsd.d8a.t.11363.0a000
Port: 3260
: 192.168.10.50
: 0.0.0.0
: iqn.2008.com.intel:r920iscsi
22