Safety Lock; 安全鎖定 - Panasonic MX-151SG2 Operating Instructions Manual

Safety Lock

安全鎖定
The safety lock has been designed to prevent the blender
from switching on when container is not properly in place.
Do not push the safety lock pin with any implement, stick etc.
When the slide ring on the back of the blender container base is
pushed during assembling, motor does not operate.
安全鎖定的設計目的是為防止在未置妥容器時就開啟攪拌
機。
請勿使用任何工具或棒狀物體等推動安全鎖定的保險栓。
組裝中，當攪拌機刀座背面的滑塊被壓住時，馬達將不會運轉。
Attach the Container to the container base properly.
After setting, make sure the backside of the container base is as shown in the ○ illustration.
正確組裝容器和容器刀座。
設置後，應確保攪拌機刀座背面如同圓 ○ 中所顯示。
pin
保險栓
14
0_MX-151SG1-050.indd 14
None of the three pins sticks
out.
三個保險栓都未突出。
Safety lock pin
安全鎖定保險栓
More than one pin stick out.
→ Reattach the container again.
一個以上的保險栓突出。
pin
→ 重新安裝容器。
保險栓
2010/05/24 11:31:15