Troubleshooting; 疑難排解 - Panasonic MX-151SG2 Operating Instructions Manual

Troubleshooting

疑難排解
Problems
The blender will not operate
even when the selector
knob has been set to the "1"
or "2" position.
The blender stops operating
midway through operation.
The ingredients being
processed are leaking out.
問題
即使將選擇器旋鈕設至「1」
或「2」的位置，攪拌機仍無
法運作。
使用中途停止運轉。
食物洩漏。
18
0_MX-151SG1-050.indd 18
Possible cause
• The blender container or mill container is not mounted correctly on the
motor housing.
• The power plug has been disconnected from the power outlet.
• The ingredients are clogging the cutter.
• The Circuit Breaker Protection of the motor has been tripped.
Check whether prohibited, hard or too many ingredients have been
placed in the container.
• The Circuit Breaker Protection will also be tripped when abnormal
sounds are heard or high levels of vibration are generated.
• The blender container or mill container is not mounted correctly.
• The gasket has not been installed.
• 攪拌機容器組立與碾磨機容器組立沒有正確安裝於本體上。
• 電源插頭已從電源插座斷開連接。
• 食材阻塞了刀片的運轉。
• 啟動了馬達的斷路器保護裝置。
檢查容器中是否有放入禁止、硬質、或過多的食材。
• 當聽見異常聲音或產生高度震動的情況時，斷路器保護裝置也會啟動。
• 沒有正確裝上攪拌機容器或碾磨機容器。
• 沒有安裝墊圈。
可能原因
Page
See P.9 &
P.12
See P.15
See P.7 &
P.9 & P.12
頁面
參見第 9
和 12 頁
參見第 15
頁
參見第 7、
9 和 12
頁
2010/05/24 11:31:17