Circuit Breaker Protection; Troubleshooting - Panasonic KM5070 Operating Instructions Manual

Circuit Breaker Protection

When the Circuit Breaker automatically stops the motor due to overloading, follow the below steps:
1
Switch off to reset the Circuit Breaker.
2
Reduce the ingredients to less than 1/2 of the working capacity and/or remove hard ingredients.
3
Resume blending. If the Circuit Breaker still activates, repeat step 1 - 2. Do not repeatedly reset the Circuit
Breaker.
:
Note
• Circuit Breaker may not reset over 40 °C room temperature. In that case please move appliance to the room
temperature under 35 °C and wait until it is cooled down.

Troubleshooting

Ensure to turn off the appliance and the power supply before taking the actions in the table below
Problems
The appliance does not turn on.
Even though the power is on, the appliance
does not start blending.
The appliance stops during blending.
The mixture in the Blender Jug is leaking.
There is abnormal noise or vibration.
The Cutting Blades is spinning freely without
cutting.
• A "kiiiiin" sound may be heard during operation. This is normal.
EN12
Causes
The Plug is not inserted into an outlet.
The Blender Jug or the Mill Container is not
placed correctly.
Overloaded with ingredients or prohibited
ingredients are used.
The Safety Lever is stuck.
The Circuit Breaker Protection is activated.
• Too many ingredients or hard ingredients
are used.
Prohibited ingredients are used.
Maximum operating time is exceeded.
The Blender Jug Base is attached loosely.
The Blender Gasket is not installed correctly. Install the Blender Gasket correctly.
The Blender Gasket is not installed.
The Safety Lever is stuck.
Too many ingredients in the Blender Jug.
The Blender Jug Base is attached loosely.
Ingredients are stuck to the wall of the
Blender Jug.
Quantity of the liquid is low.
Actions
Insert the Plug into an outlet.
Place the Blender Jug or the Mill Container correctly.
Do not exceed the working capacity of the ingredients and
ensure that prohibited ingredients are not used.
Disassemble the Blender Jug Base and follow the
assembly sequence (page EN5).
See "Circuit Breaker Protection".
Remove prohibited ingredients.
Turn off the appliance and refer to the recommended
operating time (page EN3).
Tighten the Blender Jug Base fi rmly onto the Blender Jug.
Install the Blender Gasket.
Disassemble the Blender Jug Base and follow the
assembly sequence (page EN5).
Turn off the appliance and reduce the ingredients.
Tighten the Blender Jug Base fi rmly onto the Blender Jug.
Turn off the appliance and insert the Scraper to circulate.
Add liquid.