Network Flash Transfer; Network Hold; Network Paging; Network Transfer Recall - Panasonic DBS576 Technical Manual

Section 700 - Operation
Network Extension Calling allows you to reach an extension on another PBX. Based on the number
you dial, the System network routes the call automatically.

Network Flash Transfer

When three or more systems are networked together with one System as the tandem, Network Flash
Transfer determines where a call is held when Network Hold is pressed.
Related Programming
• FF1-0-04: Trunk COS (Network Flash Forwarding)

Network Hold

Network Hold allows the user to place a call on hold by pressing a programmed line key or MCO key.
When using Network Hold, you cannot establish a conference call between nodes, and only one party
can place the call on hold.
Related Programming
• FF1-0-04: Trunk COS (Broker's Hold for Network Calls)
• FF1-1-01-0020: Network Flash Signal Timer
• FF1-2-02: FF Dial Codes: Plan A (Network Flash Send During Intercom Dial Tone)
• FF1-2-03: FF Dial Codes: Plan B (Network Flash Send During Intercom Dial Tone)
• FF4-0-BSSC-0: FF-Key Assignment (Network Flash During Talk on FF-key)

Network Paging

Network Paging allows users on one System to page on another System when the appropriate Class of
Service (COS) allows.

Network Transfer Recall

Network Transfer Recall allows a call which has been transferred to another node to recall back to the
transferring extension.

Tandem Connection

Tandem Connection allows calls that are received over the network tie lines to be automatically routed
on to another PBX or out to the public network.
Hardware Requirements
• T1 or E&M Card
Related Programming
• FF6: ARS/TRS
Considerations
• N/A
576-36-700 DBS 576 (USA) issued October 2000
Chapter 3. System Features
3-47