Panasonic DBS576 Technical Manual page 74

Chapter 3. System Features
Figure 3-2. Output data format
Format #1
T MM/DD HH:MM:SS HH:MM:SS NNNN TTTT dddddddddddddddddddddddd aaaaaaaaaa vvvvv
1 2
Format #2
T MM/DD HH:MM:SS HH:MM:SS NNNN TTTT dddddddddddddddddddddddd aaaaaaaaaa vvvv
1 2
dddddddddddddddd cccccccc mm:ss
9
1 Condition Code: (I: Incoming call / D: DID.DDI incoming call / h: Hold incoming call / N: Network
incoming call / S:DISA incoming call / t: Transfer incoming call / A: Abandoned Call / O: Outgoing
call [Non LCR] / F: Call forward outside call / H: Hold outgoing call / L: LCR outgoing call / T:
Transfer outgoing call / W: Closed Numbering call)
2
Call Start Time (MM=01 to 12 / DD=01 to 31 / HH=00 to 23 / MM=00 to 59 / SS=00 to 59)
3
Call Duration Time (HH=00 to 23 / MM=00 to 59 / SS=00 to 59)
4
CO User No. (Extension line No.: 0 to 9999 / CO line No.: C001 to C576)
5
CO line No. (CO line No.: 001 to 576 / When CO line is disconnected while the call is on hold: *001
to *576)
6
Dialed No. (24 digits max. including 0-9, *, # Cannot display Flash or Pause. If a number is hidden, *
will appear instead of digits. * will stay with the call even if the call is transferred. For Format 2, an I
Proceeds the digits if it is an incoming call.)
7
Accounting Code (10 digits max.)/Verified Account Code (Verified Account Code table number
V001 to V500)
8
DISA Security Code ID (DISA ID Code table number D001-D016)
9
Caller Data (Format #2 only)
I
SDN Charge Data (Format #2 only - originator number applies to ISDN only) - Not used (Format # 2
10
only) Future Use
Incoming Ringing Time (Format #2 only) (MM=00 to 99 / SS=00 to 59)
11
Carriage Return Line Feed
H
Related Programming
• FF2: SMDR for Outbound Calls (for Analog, E&M Tie Line, and ISDN)
• FF2: SMDR for Inbound Calls (for Analog, E&M Tie Line, and ISDN)
• FF1-006: Serial Port Receive Data
3-56
3 4 5
3 4 5
H
11
10
DBS 576 (USA) issued October 2000
6 7
6
7
Section 700 - Operation
H
8
8
576-36-700