Support Handle; Attaching Or Removing Battery Pack; Operation - Panasonic EY7460 Operating Instructions Manual

NOTE:
If excessive play occurs in the chuck,
secure the drill in place and 1 open
the chuck jaws by turning the lock collar
and 2 tighten the screw (left-handed
screw) with a screwdriver by turning
it counterclockwise (viewed from the
front).
Attaching or Removing
Battery Pack
1. To connect the battery pack:
Align the highlighted marker points and
attach battery pack.
Slide the battery pack until it locks
●
into position.
Alignment marks
2. To remove the battery pack:
Push down the button and slide the
battery pack forward.
Button
EY7460_EY7960_Book.indb 7

Support handle

Place the support handle at your
favorite position and tighten the handle
securely.
Tighten
Loosen
Remove the handle when placing the
tool in the storage case.
IV. OPERATION
[Main Body]
Switch Operation
1. The speed increases with the amount
of depression of the trigger. When
beginning work, depress the trigger
slightly to start the rotation slowly.
2. A feedback electronic controller is used
to give a strong torque even in low
speed.
3. The brake operates when the trigger
i s r e l e a s e d a n d t h e m o t o r s t o p s
immediately.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not
signal a malfunction.
* This lag occurs as the tool's circuitry
starts up when the trigger is pulled
for the first time after installing a new
battery pack or after the tool has not
been used for at least 1 minute (or
at least 5 minutes when the LED is
on). Rotation will start without any
lag during second and subsequent
operations.
- 7 -
2013-12-2 16:12:20