Cautions Safety cautions Carefully read the following information in order to operate the airconditioner correctly. WARNING! CAUTION! INSTRUCTIONS: The Safety Cautions should be at hand so that they can be checked at any time when needed. WARNING! Don't blow the human body with the cooling Please let the dealer be responsible for installing the conditioner.
Page 6
Cautions CAUTIONS! Don't operate the air-con- Conditioner should not be used for any other ditioner with damp hands. purpose other than airconditioning. Only use correctly-typed fuse. Don't place any burning unit Don't dismantle the outlet of the outdoor unit. in the air flow of air-conditioner, which may cause incomplete combustion.
Cautions Installation WARNING ! Please call dealer to install the air-conditioner. CAUTION ! Air-conditioner can't be installed in the envi- Connect earthing wire. ronment with inflammable gases because the inflammable gases near to air-conditioner may cause fire hazard. Installed electrical-leaking circuit breaker. Use discharge pipe correctly to ensure efficient discharge.
Maintenance [Clean air filter] NOTE 1. Open inlet grill 5. Install air filter 2. Open two othooks 3. Dismantle air filter 6. Close inlet grill 7. Press the filter signal return key on the controller. [Clean inlet grill] 1. Open inlet grill 4.
Page 11
Maintenance 2. Take off air-filter 3. Take of inlet grill [Dismantle and install swing plate ] 1. Fix the swing plate at the bottom. 2. Dismantle the swing plate. CAUTION! 4. Clean CAUTION! NOTE Dismantle and install swing plate When the filter too much dust 3.
Page 12
Maintenance Clean the air filter Instructions : 1. Open air inlet grille 2.Dismantle the air filter 3. Clean Use cleaner or water to clean to remove dust.
Page 13
Maintenance 4. Install air filter 5. Close air inlet grille Clean the air inlet grille 1. Open air inlet grille 2. Remove air filter 3. Remove the air inlet grille 4. Clean 5. Install air inlet grille 6. Install the air filter 7.
Page 14
Maintenance NOTE The inner part of indoor unit must be cleaned. Consult dealer, because clean must be done by technician. In cooling operation, discharging system discharge water in room.
Installation Procedure CAUTIONS: To ensure proper installation, read "Cautions" carefully before working. After installation, start the unit correctly and show customers how to operate and maintain the unit. Meanings of Warning and Cautions: Warning! Serious injury or even death might happen, if it is not observed. Caution! Injury to people of damages to machine might happen, if it is not observed.
Page 22
Installation Procedure 1. BEFORE INSTALLATION <Don't discard any accessories until comp> 2. SELECTION OF INSTALLATION PLACE (For series 122,182 ) (For series 242, 282, 362,422,522, 482, 602 ) 3. PREPARATION FOR THE INSTALLATION (For series 122,182 ) (For series 242, 282 )
Page 23
Installation Procedure (For series 482, 522,602 and AB362ACERA) 860-890 (ceiling hole) (For AB362ACEAA AB422AEEAA ) (Hanging position) Wall or barrier Barrier Ground <Installation example>...
Page 24
Installation Procedure 4. INSTALLATION OF INDOOR UNIT In the case of new ceiling < After installation on the ceiling > In the case of ceiling already exists...
Page 25
Installation Procedure 5. REFRIGERANT PIPING As for outdoor piping, please refer to installation Manual of outdoor unit. Table 1 6. INSTALLATION OF WATER DRAINAGE PIPE Cautions for the drain water lifting pipe...
Page 27
Installation Procedure After wiring When wiring is not complete...
Page 28
Installation Procedure 7. WIRING << WARNING 8. WIRING EXAMPLE Note: 9. INSTALLATION OF ORNAMENT PANEL Cautions for the installation Accessory Pad 1. Prepare ornament panel Handling of ornament panel Remove air inlet grill from ornament panel * Remove cover plate at corner...
Page 29
Installation Procedure 2. Mounting on high ceiling If connecting is not made, error code (A7) appears on remote controller. So, make proper connecting. 3. Install ornament panel on indoor unit. For indoor unit installation, please refer to Installation Manual.
Page 30
Installation Procedure 4. Installation of inlet grill and cover plate When installing inlet grill, take care not to twist wiring of swing flap motor. Pay special care to the following and check after installation Unproper installation may cause Item to the checked Check...