Dry Vacuum Cleaning; Wet Vacuum Cleaning - Sealey pc310 Instructions For Use Manual

7. DRY VACUUM CLEANING

WARNING! Ensure you read, understand and apply Section 1 'Safety Instructions'.
R
Reminder: DO NOT vacuum hazardous substances. Use of an incorrect cartridge filter will invalidate your warranty.
R
7.1. Ensure the machine is unplugged from the power supply.
7.2. Fit the cartridge filter down over the basket and push it home fully.
7.3. Re-position the head onto the tank, and clip in place.
7.4. Insert the larger end of the flexible hose into the front inlet on the tank and lock in place.
7.5. Push the required attachment onto the free end of the hose.
7.6. Plug into the power supply.
7.7. Switch the motor to vacuum only (position:
power supply.

8. WET VACUUM CLEANING

WARNING! Ensure you read, understand and apply Section 1 'Safety Instructions'. Reminder: Remove plug from power supply
R
before opening unit. DO NOT vacuum solvents, explosives, flammable and/or hazardous liquids such as petrol, oil, spirits, paint,
thinners, acids etc. Use of an incorrect filter will invalidate your warranty.
8.1. Ensure the machine is unplugged from the power supply. Make sure the tank is clean and free from dust and dirt.
8.2. For wet vacuum cleaning the foam filter must be used.
8.3. When using the foam filter first remove any cartridge filter fitted. Ensure the foam filter is clean and dry. Place the foam filter over
the filter cage and adjust carefully.
8.4. Fit the required accessories or tubes to the suction hose.
8.5. Ensure the switch is 'Off' (position '0') before plugging into the power supply.
8.6. Switch to the 'On' (position:
8.7. After use, empty the tank and dry.
WARNING! The tank is not designed for liquid storage. Always empty liquids after use. Never store the cleaner with liquid in the tank.
R
8.8. To vacuum large quantities of liquid, from a sink or tank etc., DO NOT immerse the nozzle completely in the liquid; leave a gap at
the top of the nozzle opening to allow an air inflow. The machine is fitted with a float valve which blocks the suction action when the
tank has reached its maximum capacity. The user will notice an increase in motor noise. When this happens, turn off the machine,
disconnect from power supply, remove the head from the tank and empty the liquid into a suitable receptacle or drain. To continue
to vacuum, refit the head and proceed. After wet vacuuming, turn the machine off and remove plug from power supply. Empty the
tank and clean/dry the inside and outside before storage.
© Jack Sealey Limited
). When completed, turn the switch to the 'Off' (position 'O'), and unplug from
). When completed, turn the switch to the 'Off' (position 'O'), and unplug from power supply.
Original Language Version
PC310 Issue:7(S) - 27/05/15