Using The Ir Port - NEC MOBILEPRO 900 User Manual

Press the button beside the CF card.
2.
When the card pops out slightly, pull it out of the slot.
3.

Using the IR Port

With the NEC MobilePro, you can send and receive data to and from
another similarly equipped device using the infrared (IrDA)
communication port. In addition, you can use the IR port to
synchronize data with your host PC, in place of using the PC Connect
cable.
Before using the MobilePro for IrDA communication, first
configure/enable the IR port on your host system, then install
Microsoft ActiveSync on your host system.
Note
installing Microsoft ActiveSync, you must re-install Microsoft ActiveSync
before establishing IrDA communication between systems.
Follow these steps to use the IR port to communicate with another
MobilePro or your host PC.
1. Remove the PC Connect (USB or serial) cable from the MobilePro
before attempting IrDA communication.
Open the display panels on the two units that you want to use for
2.
communication.
Position the MobilePro units so that the IR ports face each other.
3.
Position the units from 2 to 20 inches apart.
Be sure that nothing obstructs the path between the IR ports on
4.
both units, and that the ports are aligned properly.
Send your data by using the "Send To" selection in the Windows
5.
Explorer File menu.
Highlight the file you want to transfer and choose "Infrared Recipient"
from the Send To selections. Your file is transferred to the other
device. The receiving device uses the File/Receive command to
receive the infrared transmission.
If you configure/enable the IrDA port on your host system after
Using the MobilePro 4-15