Verifying Network Adapter Installation; Verifying Cable Connections - D-Link dge-560t Ethernet Adapter

Verifying Network Adapter Installation

If your Network Adapter is not installed, including the Network System
Software or Device drivers, your network will not function properly. Use these
steps to verify that your Network Adapter is properly installed.
1. Double-Click the "System" icon in the Control Panel.
2. Click the "Hardware" tab on top of the "System Properties" dialog box.
3. Click "Device Manager".
4. Double-Click "Network adapters" if you do not see any items branching out. You
should see "D-Link DGE-560T Gigabit PCI Express Ethernet Adapter" branch-
ing out after double-clicking "Network Adapters".
If you do not see any items branching out after double-clicking "Network
Adapters", your Network Adapter has not been properly installed. Start at the
beginning of the "Quick Install Guide".
If you see symbols such as yellow exclamation point or red "X" over the icon
adjacent to "D-Link DGE-560T Gigabit PCI Express Ethernet Adapter" your
adapter is not installed properly or may have a problem. Double-click the
"D-Link DGE-560T Gigabit PCI Express Ethernet Adapter" and read the
explanation of the problem. This information will be helpful if you require
technical support from D-Link.

Verifying Cable Connections

Check to see that the computer you are troubleshooting is properly connected.
Each computer must be connected from its D-Link DGE-560T with
Category 5 cables. Examine the network cables and ensure that none have
been walked-on, rolled over by chairs, caught in doors, or damaged.
Additionally, make note of and alleviate any possible electromagnetic
interference that may be affecting your network. Your network cables can be
plugged into any port on your hub except the "Uplink" port. The "Uplink" port
is only used when connecting your hub to another hub or switch.
- 7 -