Nokia IP40 User Manual page 74

5
Connecting to the Internet with Nokia IP40 Security Platform
5. From the Connection Type list, select the Internet connection you want to use.
The display changes according to the connection type you select. Perform the following
procedures in accordance with the connection type you choose.
To use a direct LAN connection
The following steps gives details about the LAN conection.
1. Select LAN connection from the procedure
page 73, the following sceen appears:
2. Enter the Host name.
This field is optional. If a service center requires it, the Host Name is provided by them.
3. Enter the maximum transmission unit (MTU-1500)
4. If you do not want the IP40 to obtain an IP address automatically by using DHCP, do the
following:
a. Uncheck the Obtain IP address automatically (using DHCP) check box.
b. Enter the IP address that your service provider provides.
c. Select the from the pull-down list subnet mask that applies to the IP address you entered.
d. Enter the IP address of the default gateway of your service provider.
e. Enter the preferred DNS server (primary) IP address.
f. Enter the alternate DNS server (secondary) IP address.
5. To assign an IP address automatically by using DHCP, but not configure DNS servers
automatically, do the following:
a. Uncheck the Obtain DNS Servers automatically check box.
b. Enter the preferred DNS server IP address.
c. Enter the alternative DNS server IP address.
6. Click Apply.
74
"Manually Configuring the Internet Setting"
Nokia IP40 Security Platform User's Guide v1.1
on