Connecting Multiple Projectors - Sony VPH-D50Q Installation Manual

Connecting Multiple Projectors

When the projectors are connected using the SIC-M or CCQ-BRS cable
Second projector
TRIGGER
IN OUT
RS-422A
PLUG IN POWER
CONTROL S REMOTE
First projector
TRIGGER
IN OUT
RS-422A
PLUG IN POWER
CONTROL S REMOTE
When connecting multiple projectors, you can project the multi-screen
picture.
Rear
IN OUT
ABL LINK Y IN
OUT
IN IN
INDEX VIDEO
IN OUT
ABL LINK Y IN
IN OUT IN
INDEX VIDEO
Video
PC-1271/1271M
equipment Switcher
Notes
• Insert the female and male plugs of the SIC-M or CCQ-BRS cable correctly.
• You can extend the SIC-M or CCQ-BRS cable between the projector and the
switcher up to 50 m.
• The video signal input to the signal interface board installed to the INPUT B
section should not exceed 70 MHz.
Setting up
• Set the SINGLE/SECOND/OTHER select switch on the switcher to
SINGLE.
• To control the projectors using the index number, set the sequential
number from 01 to 08 on each projector using the INDEX NO. switches
on the rear panel.
IFB-40 Signal Interface Board
C IN
R G B SYNC/HD VD
REMOTE1
OUT R-Y/P Y B-Y/P
R B
S VIDEO INPUT A
SIC-M or CCQ-BRS
connecting cable
C IN
R G B SYNC/HD VD
REMOTE1
OUT R-Y/P Y B-Y/P
R B
S VIDEO INPUT A
IN
to REMOTE 1 OUT
to IN on another
projector
MODE
IN OUT
IN
OUT
OUT
MODE
IN OUT
IFB-40 Signal Interface Board
SIC-M or CCQ-BRS
connecting cable
Connections
31
(EN)