Installation Assumption - NEC Express5800 User Manual

Installation Assumption

The installation and configuration instructions in this appendix assume the following:
!
You have properly completed the hardware installation.
!
You have run the BIOS Setup Utility to check system configuration.
Note
PnP must be enabled in your system BIOS.
!
You will be installing Windows
CD-ROM media.
Note
on your system, it was preconfigured at the factory. Refer to your
system's User's Guide and to the RAID Installation Guide and the
Disk Array Controller Installation Guide and User's Manual for
additional information on this option card. If you need to change the
RAID level from the factory setting, you must change the setting
before installing the operating system.
: To successfully install Windows 2000 on your system,
: If you have the optional disk array controller preinstalled
Installing and Configuring Windows 2000 and Windows NT 4.0 C-3
®
2000 Operating System from the