Removing A 5.25-Inch Device - NEC Express5800 User Manual

Removing a 5.25-Inch Device

1. Power off the system and remove the side panels as described earlier in this
chapter.
2. Remove the front panel as described earlier in this chapter.
3. Disconnect the power cable (A) and ribbon data cable (B) from the device
you are removing. See Figure 4-34.
Figure 4-34. Removing a Removable Media Device
4. Remove and save the four screws from the device.
5. Install an EMI (Electromagnetic Interference) shield over the bay from
which you removed the peripheral device.
6. Install filler panel into the front panel over the bay from which you removed
the peripheral device.
7. Replace the side panels and front panel, and power on the system.
8. Remove the drive serial number from the equipment log.
A
B
Upgrading Your System 4-31