Security Menu - NEC Express5800 User Manual

Security Menu

Note:
a password for entering Setup. The passwords are not case
sensitive.
Feature
Supervisor Password
is
User Password is
Set Supervisor
Password
Set User Password
Password on Boot
Diskette Access
Floppy Write Protect
*Secure Mode
Power Switch Mask
* Only selectable when the user password is registered.
Enabling the Supervisor Password field requires
Choices or
Display Only Description
Clear Status only, user cannot modify.
Once set, this can be disabled by
setting it to a null string, or by clearing
password jumper on system board
(see System Board Jumpers in this
Chapter).
Clear Status only, user cannot modify.
Once set, this can be disabled by
setting it to a null string, or by clearing
password jumper on system board
(see System Board Jumpers in this
Chapter).
Press ENTER Supervisor password controls access
to the setup utility.
When the <Enter> key is pressed, the
user is prompted for a password;
press ESC key to abort. Once set, this
can be disabled by setting it to a null
string, or by clearing password jumper
on system board (refer to System
Board Jumpers in this chapter).
Press ENTER When the <Enter> key is pressed, the
user is prompted for a password;
press ESC key to abort. Once set, this
can be disabled by setting it to a null
string, or by clearing password jumper
on system board (refer to System
Board Jumpers in this chapter).
Disabled Disables or enables password entry
Enabled on boot.
Everyone Controls access to diskette drives.
Supervisor
Write Protected Enable or disable data write to a
Normal floppy disk in the floppy disk drive
while the server is in the Secure
Mode.
Press ENTER
Masked Enable or disable the POWER switch
Unmasked of the server. If "Masked" is selected,
power-off with the POWER switch
becomes unavailable after OS boot-
up. (Forced shut down also becomes
unavailable. Forced shut down is a
feature to shut down by pressing the
POWER switch for at least four
seconds.)
Your Setting
Configuring Your System 3-11